Lupa Password SANSwitch BROCADE

Ehem....
pusing yach...
checked below

Pertama : http://www.foundrynet.com/ss/resource-center/lost-password.html

Recovering from a Lost Password

Please note: This procedure does not apply to the EdgeIron switches and IronPoint 200 Access Points and Sensors.
By default, the CLI does not require passwords. However, if someone has configured a password for the device but the password has been lost, you can regain super-user access to the device using the following procedure.
NOTE: Recovery from a lost password requires direct access to the serial port and a system reset.
To recover from a lost password:
1. Start a CLI session over the serial interface to the Brocade device.
2. Reboot the device.
3. While the system is booting, before the initial system prompt appears, enter b to enter the boot monitor mode.
4. Enter no password at the prompt. (You cannot abbreviate this command.)
5. Enter boot system flash primary at the prompt. This command causes the device to bypass the system password check.
6. After the console prompt reappears, assign a new password.


Kedua : https://www.ibm.com/developerworks/forums/thread.jspa?threadID=257444

1. Connect console cable to your laptop and SAN Switch
2. Open HyperTerm or Putty and connect to COM1 and restore Port Setting to default
3. Power recycle the SAN Swithch switch off and switch on
4. Press ESC when POST messages are displayed
5. The Boot PROM Menu will be shown as below:

1) Start System
2) Recover Password
3) Enter command shell

6. Choose 3 and press enter to open command shell
7. Type printenv
8. Look for the line started with OSLoader http://e.g%20*osloader=mem()0xf0000000;*mem()0xf08000000/
9. Copy the text between = and ; which is MEM()0xF0000000
10. Type boot MEM()0xF0000000
11. Type mount -o remount,rw,noatime /
12. Type mount /dev/hda2 /mnt
13. Type /sbin/passwddefault
14. You will be informed passwords are set to default
15. Type reboot -f and switch will be rebooted
16. Wait for Swith to be normally rebooted and log in as root. Default password in my case is fibranne
17. You will be prompted to change password for root, factory and admin account and do so as prompted
18. Document the password somewhere safe and disconnect console connection